dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Battery & Charging System - General Information|Page 2344 > < Battery - Overcharging/Body Corrosion|Page 2338
Page 1
background image

Technical Service Bulletin # 080386

Date: 860407

Battery & Charging System - General Information

Models

All Passenger Cars & Trucks

Subject

Battery & Charging System Information

Index

ELECTRICAL

Date

April 7, 1986

No.

08-03-86

P-1271
This bulletin outlines the proper procedures that should be followed for charging system diagnosis, battery testing, charging, and storage.

WARNING:

ALL BATTERIES GENERATE HYDROGEN GAS, WHICH IS EXTREMELY FLAMMABLE. IF IGNITED BY A SPARK OR
FLAME, THE GAS MAY EXPLODE VIOLENTLY, CAUSING SPRAYING OF ACID, FRAGMENTATION OF THE 
BATTERY, AND POSSIBLE SEVERE PERSONAL INJURIES. WEAR APPROVED EYE PROTECTION. BATTERY FLUID
IS A CORROSIVE ACID. FLUSH ANY CONTACTED AREA WITH WATER IMMEDIATELY AND THOROUGHLY.

Vehicle Storage

Today's vehicles have electronic components that require memory retention during a KEY OFF condition. Though KEY OFF loads are small, over an
extended period of time they will affect the performance of the battery. Storage at low states of charge can result in permanent battery damage due to
internal corrosion. Storage at low states of charge will also result in battery freezing. Therefore, vehicles that are NOT to be used for extended periods of
time need special attention.

To prevent battery damage you should check and charge (until the GREEN DOT appears), if necessary, all batteries upon receipt of vehicles. For
vehicles in storage, disconnect the large bullet connector supplying power to the vehicle. Check and charge all batteries prior to delivering the vehicle to
the customer.

NOTE:

THE IGNITION SWITCH MUST BE OFF WHEN CONNECTING OR DISCONNECTING BATTERY CABLES OR CHARGERS.
FAILURE TO DO SO MAY RESULT IN DAMAGE TO ELECTRONIC COMPONENTS.

Repair Area, Built-In Test & Battery Visual Inspection Information

VEHICLES IN THE REPAIR AREA

If a vehicle is going to be in the repair area for a prolonged period of time, the technician should disconnect the battery except when battery use is
required for the repair. This will avoid battery drains from an open hood, deck lid, doors, etc.

The battery is the primary component in the vehicle's electrical system. It is very important that the battery be capable of delivering the current when
necessary, as well as accepting current under charging conditions.

Another important function of the battery is as a giant capacitor (shock absorber) in the electrical system. It absorbs surges and acts as a buffer to the
electrical system under short-term high-load conditions.

All vehicles are equipped with maintenance-free batteries. They have nonremovable battery caps, and never require the addition of water. The battery is
sealed except for small vent holes in the cover. The ability to seal the battery is a result of special chemical composition changes made within the battery
and the plates. These changes allow only very small amounts of gasses to be generated under normal conditions.

BUILT-IN TEST INDICATOR

The battery contains a visual test indicator, or hydrometer, molded into the top of the battery case. The test indicator will visually display the "state of
charge" of the battery. When the battery is at an adequate state of charge (100% to 75%), the indicator will be GREEN. When charging is required, the

Battery & Charging System - General Information|Page 2344 > < Battery - Overcharging/Body Corrosion|Page 2338