B250 3/4 Ton Van V8-360 5.9L VIN 1 4-bbl (1987)
FIGURE 3-E & 3-FBODY WIRING
2.
At crossmember, route harness to the left rail following existing brake lines and tie wrap in two (2) places. At left rail, route harness forward
through access holes following existing brake lines.
NOTE:
HARNESS SHOULD BE TIGHT IN THIS AREA. TIE WRAP IN FOUR
(4)
PLACES (FIGURE 3-E).
3.
At engine compartment, route harness through existing speedometer cable clips to bulkhead connector. If excess wiring exists, loop and tie wrap in
two (2) places and install into existing clip (Figure 3-F).