B350 1 Ton Van V6-239 3.9L (1990)
Manual Window Glass Regulator
5. Remove the center of the regulator retaining rivets with a drift punch and then drill them out with a 6 mm (1/4-in) diameter drill bit. When
installed, the regulator should be retained on the door inner panel with 1/4-20 x 112 bolts and nuts.
Regulator Removal/Installation
6. Remove the regulator from the door.
INSTALLATION
1. Position the regulator in the door and retain it on the inner door panel with 1/4-20 x 1/2 bolts and nuts. Tighten the nuts with 10 Nm (90 in. lbs.)
torque.
2. Raise the glass, slide it rearward and engage the channel with the regulator arm roller.
3. Install the vent window.
4. Test the window glass and regulator operation. Correct as necessary.
5. Install the door waterdam and the trim panel, or, if applicable, the access panel.
