dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Campaign - Paint Delamination|Page 4545 > < Campaign - Paint Delamination
Page 2
background image

Use the following labor operation number and time allowance:

Labor Operation

Time

Number

Allowance

Repaint Vehicle

23609182

Actual Time

Add the cost of the materials plus applicable dealer allowance to your claim.

Note

See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.

PARTS RETURN

Not required.

Service Procedure

SERVICE PROCEDURE VIDEOTAPE

As an additional service aid, refer to the Paint Delamination Repair videotape which was distributed with the January, 1994 Master Tech program.

SERVICE PROCEDURE

1.

Wash vehicle with soap and water. Wipe dry.

2.

Clean vehicle with appropriate wax and grease remover (such as PPG DX330).

3.

Remove top coat down to primer on entire vehicle, saving as much of the primer (E-coat) as possible. Do not use chemical strippers.

NOTE:

If the turquoise paint has been covered with a second color (two tone), the two tone color area does not require refinishing. The second color will
protect against UV penetration.

4.

Blow off and clean with wax and grease remover. Mask off as necessary.

5.

Seal any areas where all primer has been removed with an anti-corrosion 2K primer (such as PPG DP Epoxy Primer).

6.

If the surface is uneven, apply a 2K surfacer primer.

7.

Block sand with 400-600 grit sand paper and clean again with wax and grease remover.

8.

Apply 2-3 coats of a single stage top color coat (such as PPG Deltron Concept Color).

NOTE

Epoxy primers are sensitive to UV light. Make sure there is enough top coat to protect them (approximately 2 mil film build).

IMPORTANT

Do not mix different paint manufacturer's materials. Read all safety data for the materials being used.

Owner Letter

EMISSIONS RECALL 

1988 THROUGH EARLY - 1991 EAGLE PREMIER AND DODGE MONACO

MODELS WITH A 3.0 LITER ENGINE

Dear Chrysler Corporation Vehicle Owner:

The Environmental Protection Agency has determined that your Chrysler car, with a 3.0 liter engine, may be in violation of Federal Emissions Standards.
Hydrocarbon and carbon monoxide levels could be above the allowable limits which were established to protect the public health from the dangers of air
pollution. For this reason, we are asking you to return your vehicle, identified by the Vehicle Identification Number on the enclosed form, to your dealer
for a special service repair. The service and required parts as described in this letter will be provided free of charge.

The needed instructions have been sent to all Dodge and Jeep0~ & Eagle dealers. The service will not hurt your engine performance or fuel economy. To
obtain this service:

^

Contact your dealer to make a service appointment.

^

Take the enclosed Owner Notification Form with you at the time of your appointment and give it to your dealer. The form identifies the vehicle and
the service that is required.

Campaign - Paint Delamination|Page 4545 > < Campaign - Paint Delamination