B350 1 Ton Van V8-360 5.9L (1994)
INSTALLATION
1. Position the upper end of the turning loop at the roof panel.
2. Install the upper anchor bolt in the roof panel. Tighten the upper anchor bolt to 40 Nm (350 in. lbs.) torque.
3. Position the cover over the upper anchor bolt.
4. Position the retractor at the seat riser with the locating tab inserted in the seat riser. Install the bolt. Tighten the anchor bolt to 36 Nm (27 ft. lbs.)
torque.
5. Position the buckle at the seat riser.
6. Install the anchor bolt in the seat riser. Tighten the anchor bolt to 40 Nm (350 in. lbs.) torque.
7. If applicable, adjust the seat position.
FIRST OR SECOND SEAT SHOULDER BELT/BUCKLE REMOVAL
NOTE: If the seat is being removed from the vehicle, the shoulder belts can be separated via the quick-disconnect coupler.
Left Shoulder Belt & Quick Disconnect Coupler
1. Depress the quick-disconnect button on the cover and slide the assembly upward.
Shoulder Belt Lower Anchor Bolt
2. Remove the lower belt anchor bolt from the seat frame.
3. Separate the cover, rear belt-end and anchor from the seat frame.
4. Raise the seat skirt and separate the front belt lower anchor plate from the seat frame.
