B350 1 Ton Van V8-360 5.9L VIN W 4-bbl (1988)
FIGURE 4-B
2.
Install supplied fuel reservoir/filter, PN 4418012, using two (2) self-tapping screws, PN 6022777 (Figure 4-B). Screws must be tightened to
95 inch pounds.
NOTE:
RUBBER SPLASH SHIELD MAY HAVE TO BE CUT OUT AROUND FUEL RESERVOIR.
3.
Remove and discard the fuel pump outlet tube, return hose, and fuel filter with rubber hoses and clamps. Install the fuel pump-to-reservoir
tube, PN 4306968 (Figure 4-B).
4.
Install return hose assembly, PN 4418006, from the fuel reservoir return nipple to the chassis tube, and clamp with hose clamp, PN 6500650,
at each end.
5.
Slide both 6" pieces of convolute sleeve, PN 4279993, over each 5/16" x 8" hose, PN 4203576.
6.
Install one 5/16" x 8" hose, PN 4203576 (with convolute sleeve, PN 4279993), from the fuel pump outlet tube to the reservoir/filter inlet
nipple and clamp with hose clamp, PN 6500651, at each end (Figure 4-B).
7.
Install the other 5/16" x 8" hose, PN 4203576 (with convolute sleeve, PN 4279993), from the reservoir outlet nipple to the carburetor fuel
