B350 1 Ton Van V8-5.9L VIN Z (1992)
To ensure correct alignment when installing interior trim panels, first install the attaching screws "finger-tight", align the trim panel at each end
and then tighten the screws with the specified torque. Avoid over-tightening the attaching screws because this can damage the trim panel and/or the
body panel screw holes.
1. Position the trim panels at the body interior side panels with the screw holes aligned.
2. Install the trim panel attaching screws in the body interior side panels. Tighten the screws with 2 Nm (17 in. lbs.) torque. Avoid over-tightening
the screws.
SIDE UPPER TRIM PANELS AND REAR CARGO DOOR HEADER TRIM PANEL REMOVAL
When removing a body interior trim panel that is overlapped by an adjacent trim panel, remove the nearest attaching screw in the adjacent trim
panel to avoid possible damage to both panels.
1. For convenience, remove the rear passenger seats. If necessary refer to the removal procedures.
Left Side Trim Panels
Right Side Trim Panels
2. As applicable, remove the front door or side cargo door header trim panel end attaching screw from the door header.
