B350 1 Ton Van V8-5.9L VIN Z (1992)
Cruise Control Servo Cable: Service and Repair
Servo Throttle Cable Assembly
Fig. 6 Speed Control Cable Adjustment
1. Remove air cleaner.
2. On carbureted models, disconnect cable from carburetor lost motion link by removing spring clip.
3. Disconnect cable from servo, then remove cable assembly.
4. On fuel injected models, hold throttle open by rotating cable remaining cam, then remove cable slug from throttle lever cam.
5. Remove cable from bracket at throttle body.
6. On all models, remove two nuts from servo mounting bracket, then pull servo away from mounting bracket.
7. Remove and discard push nuts on servo studs, then pull speed control cable away from servo to exposed servo retaining clip.
8. Disconnect cable from servo, then remove cable assembly.
9. To install, locate cable through servo mounting bracket.
10.
Connect cable sleeve to servo stud, align holes, then install clip.
11.
Insert servo studs through holes in cable and holes in bracket, then install new nuts on servo studs.
12.
Route cable from servo, through cable support bracket and clip, then install cable end on stud of throttle body.
13.
On carbureted models, adjust control cable as follows:
a. Start engine and let run, until normal operating temperature is reached.
b. Remove retaining clip.
c. Adjust clip until 1/16 inch clearance is achieved between throttle stud and cable clevis.
14.
Replace air cleaner.
