Caliber L4-1.8L (2009)
Child Seat Tether Attachment: Service and Repair
Child Seat Anchor - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
NOTE: The following procedure is for servicing the second row right inboard child restraint lower anchor and bracket. The second row right
outboard and both left lower anchors are integral to their respective seat back hinge brackets. See: Body and Frame/Seats/Seat
Back/Service and Repair/Overhaul/Seat Back - Assembly .
1. Position the child anchor bracket (5) under the second row seat back and engage it over the stud (6) on the rear floor panel (1).
2. Install and tighten the nut that secures the bracket to the stud. Tighten the nut to 80 Nm (59 ft. lbs.).
3. Reinstall the second row right and center anchor buckle unit (2) onto the rear floor panel. See: Seat Belt Buckle/Service and Repair/Seat Belt
Buckle - Installation.
