Caliber L4-1.8L (2009)
4. Secure the flex hose (2) routing bracket to the strut (6) with the mounting screw (1). Tighten the mounting screw to 13 Nm (120 in. lbs.).
5. Install tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Install
and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
6. Lower the vehicle.
7. Perform wheel alignment as necessary. See: Alignment/Service and Repair
Rear Shock Absorber, Coil-Over - Removal
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Vehicle Damage Warnings .
1. Remove the interior rear quarter trim panel. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment
Trim/Quarter Trim Panel - Removal
2. Remove the two nuts (1) securing the shock assembly (2) to the body bracket (3).
3. Raise and support the vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
