Caliber L4-2.0L (2008)
REMOVAL
1. Remove door plugs. See: Rear Door Plugs - Removal
2. Remove speaker and grille. See: Rear Door Speaker and Grille - Removal
3. Remove handle if equipped. See: Rear Door Handle/Rear Door Exterior Handle/Service and Repair/Rear Door Exterior Handle - Removal
4. Remove trim bolster.See: Rear Door Trim Panel Bolster - Removal
5. Remove glass. See: Rear Door Window Glass/Service and Repair/Rear Door Glass - Removal
6. Remove module fasteners.
7. Disconnect wire connector (5).
Rear Door Module - Installation
INSTALLATION
1. Install glass. See: Rear Door Window Glass/Service and Repair/Rear Door Glass - Installation
2. Place panel up to door, and plug in electrical connectors (5).
3. Connect wire connector to latch (3).
4. Install module to door and tighten fasteners.
5. If equipped, install window handle crank.
6. Install trim bolster. See: Rear Door Trim Panel Bolster - Installation
7. Install door plugs.See: Rear Door Plugs
8. Install door speaker and grille.See: Rear Door Speaker and Grille - Installation
Rear Door Speaker and Grille - Removal
REMOVAL