Caliber L4-2.0L (2008)
Keyless Entry Module: Service and Repair
Sentry Key Remote Entry Module - Removal
REMOVAL
NOTE: The steering wheel does not have to be removed to service the SKREEM/WCM.
NOTE: The Steering Column Control Module (SCCM) assembly, which consists of the left/right multi-function switches and the clockspring,
does not have to be removed to service the SKREEM/WCM. There is an access hole in the top of the right multi-function switch to access the
mounting screw (2).
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, personal injury or death.
2. Remove the upper and lower steering column shrouds See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service
and Repair/Shroud - Upper/Removal and See: Steering and Suspension/Steering/Steering Column/Steering Column Cover/Service and
Repair/Shroud - Lower/Removal.
3. Remove the SKREEM/WCM mounting screw (2) on the ignition lock assembly and separate the SKREEM/WCM (3) from the ignition lock
assembly.
4. Disconnect the SKREEM/WCM electrical connector (4).
5. Remove SKREEM/WCM (1 and 3) from column (2).
When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order See: Powertrain Management/Computers and
Control Systems/Engine Control Module/Testing and Inspection.
-
Program the new PCM.
-
Program the new SKREEM/WCM.
-
Replace all ignition keys and program them to the new SKREEM/WCM.
