Caliber L4-2.0L (2008)
11. Bleed the caliper as necessary. See: Brake Bleeding
12. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoes.
Front - SRT4
INSTALLATION
CAUTION: Always inspect the brake pads before installing the disc brake caliper and replace as necessary. See: Brake Pad/Service and
Repair/Procedures/Brake Pads - Inspection
1. Completely retract the caliper pistons back into their bores in the caliper. Hand pressure or a C-clamp may also be used to retract the pistons, first
placing a wood block over the pistons before installing the C-clamp to avoid damaging the pistons.
CAUTION: Use care when installing the caliper onto the adapter bracket to avoid damaging the guide pin boots.
2. Push caliper guide pins into the caliper adapter as far as possible to allow clearance when installing caliper.
3. Install the disc brake caliper (1) over the brake pads on the brake caliper adapter bracket (3).
4. Align the caliper guide pin bolt holes with the adapter bracket. Install the upper and lower caliper guide pin bolts (2). Tighten the guide pin bolts
to 60 Nm (44 ft. lbs.).
