Caliber L4-2.0L (2008)
10. Loosen, but do not remove, the two mounting screws (2) attaching the ICU (1) mounting bracket to the body.
11. Lift the ICU and mounting bracket (1) off the mounting screws (2).
12. Move the brake tubes around as necessary without bending them and remove the ICU with bracket through the opening between the A/C lines and
the exhaust manifold.
13. To separate the ABM from the HCU, See: Overhaul/Disassembly.
Integrated Control Unit - Gas Turbo Engine
INTEGRATED CONTROL UNIT - GAS TURBO ENGINE
NOTE: Before proceeding, See: Service Precautions/Brakes - Caution.
1. Disconnect and isolate battery negative cable from battery post.
2. Using a brake pedal holding tool as shown, depress the brake pedal past its first 25 mm (1 inch) of travel and hold it in this position. This will
isolate the master cylinder from the brake hydraulic system and will not allow the brake fluid to drain out of the master cylinder reservoir while the
lines are disconnected.
3. Remove the engine appearance cover.
4. Loosen lower and upper mounting nuts, then remove the exhaust heat shield from the dash panel.
