Caliber L4-2.0L (2008)
8. Disconnect the ABM harness connector from the Antilock Brake Module (ABM). To do so:
a. Depress the tabs on each side of the connector cover, then
b. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be
pulled straight outward off the ABM (1).
9. Loosen, but do not remove, the two mounting screws (3) attaching the ICU (1) mounting bracket and heat shield (2) to the body.
10. Lift the heat shield (2) off the mounting screws (3).
11. Lift the ICU and mounting bracket (1) off the mounting screws (3).
12. Move the brake tubes around as necessary without bending them and remove the ICU with bracket through the opening between the A/C lines and
the exhaust manifold.
13. To separate the ABM from the HCU, See: Overhaul/Disassembly.
Integrated Control Unit - Gas Engine
INTEGRATED CONTROL UNIT - GAS ENGINE
