Caliber L4-2.0L (2008)
Cruise Control Switch: Service and Repair
Installation
INSTALLATION
1. Install speed control switch (3) onto the locating pin (2) in the steering wheel. Make sure rubber seal is in place around switch.
2. Install speed control switch mounting screws (4) and tighten screws to 1.6 Nm (15 ins. lbs.).
3. Connect electrical connector (1) to speed control switch (3).
4. Install horn switch (2) to steering wheel.
5. Connect electrical connector (1) to horn switch (2).
6. Install horn switch mounting screws (3) and tighten screws to 8 Nm (71 ins. lbs.).
7. Install driver's side airbag See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Airbag - Installation.
8. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).
9. Verify vehicle and system operation.
