Caliber L4-2.0L (2008)
Camshaft: Procedures
Measuring Camshaft End Play
MEASURING CAMSHAFT END PLAY
1. Using a suitable tool, move camshaft as far rearward as it will go.
2. Zero dial indicator.
3. Move camshaft as far forward as it will go.
4. Record reading on dial indicator. For end play specification, See: Specifications/Engine Specifications.
5. If end play is excessive, check cylinder head and camshaft for wear; replace as necessary.
Camshaft - Cleaning
CLEANING
Clean camshafts with a suitable solvent.
Camshaft - Inspection
INSPECTION
1. Inspect camshaft bearing journals for damage. If journals are damaged, check the cylinder head for damage. Also check cylinder head oil holes for
clogging.
2. Check the cam lobe and bearing surfaces for abnormal wear and damage. Replace camshaft if defective.
NOTE: If camshaft is replaced due to lobe wear or damage, always replace the lash buckets.
