Caliber L4-2.0L (2008)
19. Check crankshaft end play See: Procedures.
20. Install connecting rod bearings and caps. Do Not Reuse Connecting Rod Bolts. Tighten connecting rod bolts to 20 Nm + 90° (15 ft. lbs.) + 90°
See: Piston/Service and Repair/Removal and Replacement/Piston and Connecting Rod - Installation.
21. Install the ladder frame assemblySee: Service and Repair/Removal and Replacement/Ladder Frame - Installation.
22. Install the balance shaft moduleSee: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Engine Oil Pump - Installation.
23. Install crankshaft position sensor (2) and tighten bolt (1).
24. Install cylinder head if it was removed See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head - Installation.
25. Install front crankshaft sprocket (1).
26. Install the timing chainSee: Timing Components/Timing Chain/Service and Repair/Removal and Replacement/Timing Chain & Sprockets -
Installation.
27. Install the timing chain front coverSee: Timing Components/Timing Cover/Service and Repair/Timing Cover - Installation.
28. Install the oil pan See: Engine Lubrication/Oil Pan/Service and Repair/Engine Oil Pan - Installation.
29. Install rear crankshaft oil sealSee: Seals and Gaskets/Crankshaft Main Bearing Seal/Service and Repair/Installation.
30. Install front crankshaft oil sealSee: Seals and Gaskets/Front Crankshaft Seal/Service and Repair/Installation.
