Caliber L4-2.0L (2008)
2. Remove cylinder head cover See: Valve Cover/Service and Repair/Cylinder Head Cover - Removal.
3. Remove camshaftsSee: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal and Replacement/Camshaft - Removal.
4. Mark valve tappet location for assembly.
5. Remove valve tappets.
6. With air hose attached to adapter tool installed in spark plug hole, apply 90-120 psi air pressure.
CAUTION: Care must be taken not to damage the tappet bore or engine damage may result.
7. Using metric valve keeper tool (1) such as Snap-on(R) GA317 (or equivalent), and remove valve spring keepers and retainer.
8. Remove valve spring(s).
9. Remove valve stem seal(s) by a using valve stem seal tool.
Cylinder Head Off
CYLINDER HEAD OFF
CAUTION: Care must be taken not to damage the tappet bore or engine damage may result.
