Caliber L4-2.0L (2008)
NOTE: LHD model shown. RHD model similar.
10. Connect the rear seat floor duct (2) to the rear floor distribution duct (3). Make sure the ducts are fully engaged to each other.
11. Engage the retainer that secures the rear seat floor duct to the floor support (4) and install the retaining screw (1). Tighten the screw to 2.2 Nm (20
in. lbs.).
12. Reinstall the carpet See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair/Carpet - Installation.
13. Install the front seat to the side of the vehicle being serviced See: Body and Frame/Seats/Service and Repair/Seat - Installation.
14. Install the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console - Installation.
Instrument Panel Ducts - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: Illustrations shown with instrument panel removed from vehicle for clarity.
LEFT AND RIGHT SIDE DUCT
NOTE: The left and right side instrument panel ducts are serviced only as an assembly with the left or right side demister duct.
