Caliber L4-2.0L (2008)
5. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.
HVAC Housing
HOUSING-HVAC
NOTE: LHD model with A/C shown in illustrations. RHD and heater-only models similar.
1. If removed, install the seal (4) onto the evaporator tube tapping block (5).
NOTE: Make sure that the foam insulator is properly positioned in the HVAC housing.
2. Carefully install the A/C evaporator (1) and foam insulator (2) into the lower half of the HVAC housing (3).
3. Install the two halves of the HVAC housing (4) together and engage the nine plastic retaining tabs (1). Make sure the retaining tabs are fully
engaged.
4. Install the nine screws (3) and three metal clips (5) that secure the two halves of the HVAC housing together. Tighten the screws to 1.2 Nm (10 in
lbs.). Make sure the metal clips are fully engaged to the housing halves.
5. Install the foam seal (2) onto the front of the two HVAC housing halves.