Caliber L4-2.0L (2008)
Headlamp Bulb: Service and Repair
Removal
BULBS
NOTE: The headlamp bulb can be accessed from under the hood without the removal of the inner fender well. It will be necessary to remove
the inner fender well to service the park/turn signal bulb that is located toward the outboard side of the head lamp unit.
1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Working in the appropriate wheel well, loosen up the front of the splash shield, but don't fully remove it.
4. Looking up through the front wheel well, locate the bulb (1) in which needs replacing. The headlamp bulb is the inboard bulb and the park/turn
signal bulb is the outboard bulb.
5. Disconnect the bulb electrical connector (2 or 3).
6. Grasp the bulb (1), twist 1/4 turn counterclockwise and pull straight out of front lamp unit.
