Caliber L4-2.0L (2008)
Marker Lamp Bulb: Service and Repair
Installation
BULBS
NOTE: The headlamp bulb can be accessed from under the hood without the removal of the inner fender well. It will be necessary to remove
the inner fender well to service the park/turn signal bulb that is located toward the outboard side of the head lamp unit.
1. Reaching up through wheel well, install the headlamp or park/turn signal bulb (1) in the front lamp unit, locking it into place by twisting a 1/4 turn
clockwise.
2. Connect the bulb electrical connector (2 or 3).
3. Install the front of the splash shield (6) removed to gain access to the front lamp unit bulbs See: Body and Frame/Fender/Front Fender/Front
Fender Liner/Service and Repair/Front Wheelhouse Splash Shield - Installation.
4. Lower vehicle from hoist.
5. Connect the battery negative cable.
