Caliber L4-2.0L (2008)
8. Remove the wheel mounting nuts (3), then the front tire and wheel assembly (1).
CAUTION: The strut clevis-to-knuckle attaching bolt shanks are serrated and must not be turned during removal. Remove the nuts while
holding the bolts stationary, then tap the bolts out using a punch.
9. Remove the original upper bolt (1) and nut (3) attaching the strut clevis bracket (2) to the knuckle (5).
10. Install a bolt from the adjustment package into the hole where the original bolt was removed. Install the bolt as indicated.
11. Install a nut provided in adjustment package on the replacement bolt. Tighten the nut until it's snug, but still allows the knuckle to slide in the
clevis bracket.
12. Remove the original lower bolt (6) and nut (4) attaching the strut clevis bracket (2) to the knuckle (5).
13. Install a bolt from the adjustment package into the bottom hole of the strut clevis bracket. Install the bolt as indicated.
14. Install a nut provided in adjustment package on the replacement bolt. Tighten the nut until it's snug, but still allows the knuckle to slide in the
clevis bracket.
