Caliber L4-2.0L (2008)
Power Steering Line/Hose: Service and Repair
Power Steering Hoses - Installation
Pressure Hose - Gas Engine
GAS ENGINE
CAUTION: Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface
that can possibly damage the hoses.
1. Using a lint free towel, wipe clean the open power steering hose end and the power steering pump port. Replace any used O-rings with new.
Lubricate the O-ring with power steering fluid.
2. Install the power steering pressure hose into the engine compartment from below.
3. Install the fasteners (1) securing the power steering hose routing clamps (2) to the crossmember. Use a NEW push clip on the left and tighten the
screw on the right to 8 Nm (71 in. lbs.).
4. Install the pressure hose (2) at the gear (3). Tighten the tube nut to 32 Nm (24 ft. lbs.).
5. Install the return tube (1) at the gear (3). Tighten the tube nut to 20 Nm (15 ft. lbs.).
