Caliber L4-2.0L (2008)
3. Install the return hose onto the cooler tubes (5) and install the hose clamps (6).
4. Raise and support the vehicle. See: Vehicle Lifting/Service and Repair
5. Install the screw (2) securing the return hose to the frame rail. Tighten the screw to 19 Nm (14 ft. lbs.).
6. Install the return hose (1) at the return tube (2).
7. Lower the vehicle.
8. Install the right headlamp. See: Lighting and Horns/Service and Repair/Front Lamp Unit - Installation
9. Install the front fascia. See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair/Front Fascia - Installation
10. Install the windshield washer reservoir. See: Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Washer Reservoir -
Installation
11. Install the power steering fluid reservoir. See: Steering and Suspension/Steering/Power Steering/Power Steering Fluid Reservoir/Service and
Repair/Power Steering Fluid Reservoir - Installation
12. Install the coolant recovery bottle. See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Coolant Recovery
Container - Installation
13. Fill and bleed the power steering system. See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair
14. Check for leaks.
15. Install the engine appearance cover.
Supply Hose - Gas Engine
GAS ENGINE
