Caliber L4-2.0L (2008)
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
3. Remove the driver airbag See: Driver Airbag - Removal.
4. With driver airbag removed, pick a corner and push down on the inflator or latch hook mounting plate (1) until the latch hooks (2) push out of the
driver airbag cover (3).
5. Starting at a point on the airbag, work your way around the airbag until all the hooks have been released.
6. Remove driver airbag trim cover from driver airbag.
Installation
INSTALLATION
