Caliber L4-2.0L (2008)
REMOVAL
NON-DEPLOYED AIRBAG
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, serious or fatal injury.
3. Remove both left and right A-pillar trim panels See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/A-Pillar
Trim Panel-Removal.
4. Remove instrument panel top cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Cover - Removal.
5. Remove the glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument Panel Glove Box -
Removal.
6. Remove two attaching nuts (2) retaining PAB to instrument panel assembly inside glove box opening.
7. Partially raise airbag cover and airbag unit to gain access to the squib connectors.
NOTE: The airbag wiring is secured to the lower portion of the right hand side "A" pillar. Disengaging the harness routing clip at this
point will allow the passenger airbag assembly to be lifted higher to gain access to the squib connectors.
8. Disconnect the instrument panel wiring routing clip (1).
9. Disconnect the two PAB squib connectors (1).
10. Remove PAB from vehicle.
DEPLOYED AIRBAG
