Caliber L4-2.0L (2008)
5. Position the wheel speed sensor cable routing clamp (3) on the rear suspension crossmember (4) and install the mounting screw (1). Tighten the
mounting screw to 18 Nm (13 ft. lbs.).
6. Install the speed sensor cable routing clip (3) on the outside frame rail (4).
NOTE: When inserting the wheel speed sensor cable through the hole in the body, route the cable toward the shock tower to make it
easier to grasp the cable to connect it to the body wiring harness connector in a later step.
7. Insert the wheel speed sensor cable (5) through the hole in the body (1) and install the grommet (2) in the hole.
