Caliber L4-2.0L (2008)
10. Clean all foreign matter from the threads of the halfshaft stub shaft.
11. Install the washer (6) and hub nut (3) on end of halfshaft stub shaft (5). While a helper applies the brakes to keep the hub (4) from rotating, tighten
the hub nut to 244 Nm (180 ft. lbs.).
12. Install the spring washer (2) and hub nut lock (7) over the hub nut and stub shaft. Install a NEW cotter pin (1) securing nut lock in place and wrap
the cotter pin prongs tightly around the nut lock.
13. Install tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Install
and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
14. Lower the vehicle.
NOTE: If the original knuckle is being reinstalled, wheel alignment may not be necessary due to Net-Build design.
15. Perform wheel alignment as necessary. See: Alignment/Service and Repair
