Caliber L4-2.0L (2008)
3. Install tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Install
and tighten wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
4. Lower the vehicle.
5. Position the vehicle on an alignment rack/drive-on lift. Raise the vehicle as necessary to access mounting bolts and nuts.
6. Tighten the upper control arm mounting bolt at the crossmember to 95 Nm (70 ft. lbs.).
7. Tighten the upper control arm mounting bolt nut at the trailing link to 95 Nm (70 ft. lbs.).
8. Perform wheel alignment as necessary. See: Alignment/Service and Repair
Rear Lower Control Arm - Removal
REMOVAL
1. Raise and support the vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1).
