Caliber L4-2.0L (2008)
Seals and Gaskets: Service and Repair
Seal-Halfshaft Right Side
Removal
REMOVAL
1. Remove halfshaft See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Removal.
2. If all wheel drive remove the PTU .
3. Remove the seal (2) form the transaxle using a screwdriver (3).
Installation
INSTALLATION
1. Install the seal using Installer 9877(2) and Handle C-4171 (3).
2. If all wheel drive install the PTU .
3. Install Halfshaft See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Installation.
4. Road test vehicle and inspect for leaks.