Caliber L4-2.0L VIN B (2007)
b.
PM: Remove wiring and convolute tubing from retainers and wrap with Open Cell Foam Tape, (p/n 05019057AA) in the areas described in
below. Any wiring or convoluted tubing that is not wrapped or can come in contact with the door module shell should be wrapped with foam
tape as shown in (Fig. 7) below. Reinstall wiring and convolute tubing back in retainers.
18.
Cut the Closed Cell Low Density Foam Tape, (p/n 05019058AA) into 1" lengths and stack (if needed) to back up actuator rods with Itch and
Squeak Tape, (p/n 05019054AA) as top layer, as shown in (Fig. 8) below.
NOTE:
If # 2 below is not existing, install it.
