Caliber L4-2.0L VIN B (2007)
20.
Remove wiring and convolute tubing from retainers and wrap with Open Cell Foam Tape, (p/n 05019057AA), in the areas described in below.
Any wiring or convoluted tubing that is not wrapped or can come in contact with the door module shell should be wrapped with foam tape as
shown in (Fig. 1) for MK and (Fig. 2) for PM. Reinstall wiring and convolute tubing in retainers.
21.
Follow specific instructions based on vehicle below:
a.
MK: Cut the Closed Cell Low Density Foam Tape, (p/n 05019058AA) into 25 mm (1 in.) lengths and stack, (if needed), to back up actuator
rods as shown in (Fig. 1), above. Place a piece of Itch and Squeak Tape, (p/n 05019054AA) on the top layer of Closed Cell Low Density
Foam Tape where it contacts actuator rod.
b.
PM: Cut the Closed Cell Low Density Foam Tape, (p/n 05019058AA) into 12 mm (.5 in.) length to back up actuator rod as shown in (Fig.
3) below.
NOTE:
