Caliber L4-2.0L VIN B (2007)
Actuator rod is removed and pulled from stay for easy installation
22.
Turn door module over, (face up) and cut 6 lengths of Open Cell Foam Tape, (p/n 05019057AA) into 6.5 mm (.25 in.) strips lengthwise. Install on
door bolster TOP and BOTTOM horizontal surfaces on the smooth surface where it meets door module opening. Start at the forward most section
of the bolster to the rear most area of the horizontal surface isolating the Bolster from the mating surface of the door Panel Module. See (Fig. 4)
below. Bottom of Bolster is shown, Top is similar.
23.
Loosely install the lower bolt(s), (10 mm hex), for window regulator in bottom of door module. Thread bolt(s) into door module so that threads
protrude through module about 12 mm, (.5 in.) then start threads into bottom of regulator. Bolt should now be threaded into door module and
regulator with a space in between regulator and door module. Be sure window regulator guide tab is in proper position in door module.
24.
Position door module in door shell making sure to slip wiring to body, (at front of door), behind weather-strip and guide window regulators and
door latch mechanisms in place inside door shell.
25.
Align top of door module in position and slide down in place. Lower window regulator bolts installed earlier in step Step # 23 should slide in "V"
notch(s) in bottom of door with regulators inside door shell.
