Caliber L4-2.0L VIN B (2007)
19.
Follow specific instructions based on vehicle below:
a.
MK: cut 12 mm (.5 in) Open Cell Foam Tape, (p/n 05019057AA) and put at top rear corner of door module as shown in (Fig. 9) below. Do
not allow Foam Tape to protrude past outside edge of door module.
b.
PM: cut 1.5 in Closed Cell Low Density Foam Tape, (p/n 05019058AA) and put at top rear corner of door module, inside outer lip as shown
in (Fig. 10) below. Do not allow Foam Tape to protrude past outside edge of door module.
20.
Turn door module over, (face up) and cut 6 lengths of Open Cell Foam Tape, (p/n 05019057AA) into 6.5 mm (.25 in.) strips lengthwise. Install on
door bolster TOP and BOTTOM horizontal surfaces on the smooth surface where it meets door module opening. Start at the forward most section
of the bolster to the rear most area of the horizontal surface isolating the Bolster from the mating surface of the door Panel Module. See (Fig. 4)
above for front door.
21.
Loosely install the longer bolt, (10 mm hex), for window regulator in bottom of door module. Thread bolt into door module so that threads
protrude through module about 9.5 mm, (.375 in) then start threads into bottom of regulator. Bolt should now be threaded into door module and
regulator with a space in between regulator and door module, similar to (Fig. 5) above. Be sure window regulator guide tab is in proper position in
door module.
