Caliber L4-2.0L VIN B (2007)
7.
Remove adhesive backing and install the blocks to the liftgate, just inside the area of the lower corners of the license plate (Fig. 1).
8.
If a license plate frame is installed, foam tape should be applied to the backside of the frame to prevent rattling against the liftgate.
NOTE:
Use an appropriate amount of foam to isolate the frame.
9.
Install plate and frame, (if equipped) on liftgate and perform a liftgate "slam test to assure the plate and or frame does not rattle.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
