Caliber L4-2.0L VIN B (2007)
6. Install two NEW master cylinder mounting nuts (3). Tighten each nut to 25 Nm (18 ft. lbs.).
7. If equipped with a manual transaxle and a new reservoir is being installed, using an appropriate cutting tool, cut the clutch actuator port at the
center of the "V" groove (2) opening the hydraulic clutch port (1). Discard the severed plug (3).
8. If equipped with a manual transaxle, slide the clutch actuator hose (2) onto the reservoir port (1). Install the hose clamp just past the upset bead on
the port.
