Caliber L4-2.0L VIN B (2007)
6. Remove the stop lamp switch (2) and discard it. Do not reuse the stop lamp switch.
7. Remove the retaining clip (2) securing the power brake booster push rod (1) to the brake pedal. To do so, position a small screwdriver under the
center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3).
Remove and discard the clip. Do not reuse the clip.
8. Slide the booster push rod (1) off the brake pedal pin (3).
