Caliber L4-2.0L VIN B (2007)
CAUTION: Because of power brake booster design, it is very important to tighten the mounting nuts in the proper sequence.
3. Tighten the brake pedal/booster mounting nuts in the proper sequence to 23 Nm (17 ft. lbs.).
4. Using Mopar(R) Lubriplate, or an equivalent, coat the surface of the brake pedal pin (3) where it contacts the brake booster input rod (1).
5. Install the power brake booster push rod (1) on the pin (3) mounted on the side of the brake pedal. Install a NEW retaining clip (2) on the end of
the pin. Do not reuse the old clip.
