Caliber L4-2.0L VIN B (2007)
e.
Attempt restarting engine until it will no longer run.
f.
Turn ignition key to OFF position.
2.
Remove air inlet duct over the battery.
3.
Disconnect the battery.
NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
4.
Remove the engine cover and the plastic retainers on the valve cover studs.
5.
Disconnect the electrical connectors on the ignition coils.
6.
Disconnect the PCV and make-up air hoses from cylinder head cover.
7.
Unfasten the electrical harness and its retainer clips from the cylinder head cover studs.
8.
Disconnect the fuel line at the engine fuel rail.
9.
Use compressed air to blow dirt and debris off the cylinder head cover.
10.
Remove the cylinder head cover, ignition coils, bolts and studs as a complete assembly.
CAUTION:
Do not remove the coils from the cylinder head cover at this time to minimize dirt from entering the engine during disassembly.
11.
On the bench, remove the four ignition coils from the cylinder head cover.
