Caliber L4-2.0L VIN B (2007)
2. Reposition the defroster duct support (4) to the instrument panel and install the two retaining screws (1). Tighten the screws to 3 Nm (27 in. lbs.).
3. Install the two screws (3) that secure the defroster duct to the defroster duct support. Tighten the screws to 2.2 Nm (20 in. lbs.).
4. Connect the left demister duct (7) and the right demister duct (5) to the defroster duct.
5. Install the instrument panel top cover.
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in an accidental airbag deployment and possible personal injury or death.
RIGHT FRONT FLOOR DUCT
NOTE: LHD model shown. RHD model similar.
1. Remove the instrument panel.
2. Disconnect the right floor duct (1) from the right side of the HVAC housing (2) and remove the duct.
LEFT FRONT FLOOR DUCT
NOTE: Illustration shown with instrument panel removed for clarity.
