Caliber L4-2.0L VIN B (2007)
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: The left and right side demister ducts are serviced only as an assembly with the left or right side instrument panel duct.
NOTE: Illustration shown with instrument panel removed from vehicle for clarity.
NOTE: LHD model shown. RHD model similar.
1. Remove the instrument panel top cover.
2. Disconnect the left side demister hose (3) and right side demister hose (5) from the defroster duct (4).
3. Remove the screws (2) that secure each demister duct (1 and 6) to the instrument panel support.
4. Remove the push-pin fastener (8) that secures each instrument panel duct (7 and 10) to the instrument panel support.
5. Disconnect the left and right side instrument panel ducts from the center duct (9).
6. Remove the each demister duct and instrument panel duct as an assembly from the instrument panel.
Installation
INSTALLATION
NOTE: The left and right side demister ducts are serviced only as an assembly with the left or right side instrument panel duct.
NOTE: Illustration shown with instrument panel removed from vehicle for clarity.
