Caliber L4-2.0L VIN B (2007)
Marker Lamp Bulb: Service and Repair
Removal
BULBS
1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Working in the appropriate wheel well, loosen up the front of the splash shield, but don't fully remove it.
4. Looking up through the front wheel well, locate the bulb (1) in which needs replacing. The headlamp bulb is the inboard bulb and the park/turn
signal bulb is the outboard bulb.
5. Disconnect the bulb electrical connector (2 or 3).
NOTE: EXPORT ONLY - If removing/replacing the headlamp bulb on export vehicles there is a rubber cover over the rear of the lamp housing
that must be removed to access the bulb. Then a spring clip must be removed and the bulb pulled straight rearward.
6. Grasp the bulb (1), twist 1/4 turn counterclockwise and pull straight out of front lamp unit.