Caliber L4-2.0L VIN B (2007)
NOTE: Make sure the ends of the Bleeder Tubes stay below the surface of the brake fluid in the reservoir at all times during the bleeding
procedure.
4. Fill the brake fluid reservoir with fresh Mopar(R) Brake Fluid DOT 3 Motor Vehicle, or equivalent.
5. Using an appropriately sized wooden dowel as a pushrod, slowly press the pistons inward discharging brake fluid through the Bleeder Tubes, then
release the pressure, allowing the pistons to return to the released position. Repeat this several times until all air bubbles are expelled from the
master cylinder bore and Bleeder Tubes.
6. Remove the Bleeder Tubes and Adapters from the master cylinder and plug the master cylinder outlet ports.
7. Install the fill cap on the reservoir.
8. Remove the master cylinder from the vise.
9. Install the master cylinder on the vehicle.
