Caliber L4-2.0L VIN B (2007)
Fuel Supply Line: Description and Operation
DESCRIPTION - FUEL LINES/HOSES AND CLAMPS
Also refer to Quick-Connect Fittings.
WARNING: The fuel system is under a constant pressure (even with the engine off). Before servicing any fuel system hoses, fittings or lines,
the fuel system pressure must be released. Refer to the fuel system pressure release procedure. This may result in personal injury or death.
The lines/tubes/hoses used on fuel injected vehicles are of a special construction. This is due to the higher fuel pressures and the possibility of
contaminated fuel in this system. If it is necessary to replace these lines/tubes/hoses, use new original equipment lines/tubes/hoses.
If equipped: The hose clamps used to secure rubber hoses on vehicles are of a special rolled edge construction. This construction is used to prevent the
edge of the clamp from cutting into the hose. Only these rolled edge type clamps may be used in this system. All other types of clamps may cut into the
hoses and cause leaks.
Use new original equipment type hose clamps.
