Caliber L4-2.0L VIN B (2007)
a.
Return to the "Main Menu" (Home Page).
b.
Select "System View".
c.
Select "All DTC's".
d.
Select "Clear All Stored DTC's" and follow the screen prompts.
12.
Disconnect and remove the StarSCAN and battery charger from the vehicle.
B.
Reprogram the ABS Control Module Using StarMOBILE
NOTE:
The StarMOBILE scan tool must be at version 7.03 or higher before this procedure can be performed.
1.
Open the hood and install a battery charger. Verify that the charging rate provides approximately 13.5 volts.
2.
Connect the StarMOBILE scan tool to the vehicle data link connector located under the steering column and turn the ignition key to the
"RUN" position.
3.
Power ON the StarMOBILE scan tool.
4.
Connect the CH9410 ethernet cable to the StarMOBILE and the dealer's network drop.
5.
From the desktop, launch the "StarMOBILE Desktop Client" software.
6.
From the main menu on the StarMOBILE, select "System Status".
7.
Establish a connection with the StarMOBILE scan tool.
8.
Select "Flash Download".
9.
Select "Next" and then enter your ID and password.
10.
Enter the vehicle information (manually or use the automatic function).
11.
Highlight the required flash file and select "Download to Client".
12.
Select "BACK" then select "ECU View".
13.
Select "ABS Antilock Brakes".
14.
Select "More Options".
15.
Select "ECU Flash".
16.
Select "Manage Files".
17.
Highlight downloaded flash file.
18.
Select "Copy to SM Devise" and then follow the screen prompts.
19.
Disconnect the ethernet cable from the StarMOBILE scan tool.
20.
Turn off the StarMOBILE scan tool and then restart the scan tool.
NOTE:
The StarMOBILE scan tool must be shut down and restarted to unlock the flash.
21.
From the "System Status" screen press the "Exit" button.
22.
From the "Main Menu" select "Enter Standalone Diagnostic Mode".
23.
Select "ECU View" and press the select button.
