Caliber L4-2.0L VIN B (2007)
1. Connect the knee blocker airbag electrical connector by pushing firmly until it snaps into place.
2. Position the knee blocker airbag with trim cover (5) in the instrument panel cavity.
3. Reach up behind the instrument panel and install the two outer knee blocker airbag retaining nuts (3). Tighten nuts to 10.5 Nm (93 in. lbs.). If the
middle nut was removed by accident, this is the smaller flanged nut than the outside nuts to allow it to pass through the larger middle
hole.
4. Install the two knee blocker airbag cover (5) screws (4).
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
