Caliber L4-2.0L VIN B (2007)
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
2. Remove the B-pillar lower trim panel.
3. Disconnect the harness connector (4) from the sensor (2).
4. Remove the screw (1) retaining the B-pillar side impact sensor (2)
5. Remove the sensor (2) from the vehicle.
Side - C-Pillar
SIDE - C-PILLAR
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
2. Remove the rear quarter panel trim.
3. Remove the screw (4) that secures the side impact sensor (3) to the C-pillar (1).
4. Disconnect the harness connector (2) from the sensor (3).
5. Remove the sensor from the C-pillar.
