Caliber L4-2.0L VIN B (2007)
Impact Sensor: Service and Repair
Installation
Front
FRONT
1. Position the right or left front impact sensor (3) into the engine compartment near it mounting area.
2. Connect the harness connector (1) to the sensor.
3. Position the sensor onto the back of the right or left radiator support vertical member (2).
NOTE: Be certain that the anti-rotation pin on the back of the sensor is engaged in the lower clearance hole of the radiator support.
4. Install and tighten the screw (4) that secures the sensor (3) to the back of the support vertical member (2). Tighten the screw to 8 Nm (71 in. lbs.).
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
Side - B-Pillar
SIDE - B-PILLAR
